The electric planer is an important tool in the professional tools, so do you know about the electric planer? Do you know what the electric planer is for? Then let's learn together.
Electric planer start before the preparation.
1.The product workpiece must be clamped firmly in the tooling fixture or workbench, clamped product workpiece pressure plate can not be long out of the operating table, the maximum stroke in the machine tool shall not stand people. The blade must not be stretched out too long, and should be clamped firmly.
2.When correcting the product workpiece, do not use metal material objects to knock or use the tool holder to push the product workpiece.
3.When the total width of the product workpiece exceeds the total width of the single-arm planer processing, the offset of the center of gravity to the center of gravity of the operating table cannot exceed one-fourth of the total width of the operating table.
4. Adjusting the stroke should ensure that the blade does not touch the product workpiece, shaking with the handle to carry out the full stroke experiment, the ram should be locked and the shaking handle removed at any time after adjustment to prevent damage to life safety from falling.
5.Gantry planer bed or product workpiece outreach is too long, should be set up with protective rails, in the protective fence shall not pass pedestrian or stacked objects.
6.Gantry planer in planing large product workpiece before, need to check the product workpiece and gantry column, the gap between the tool holder, and check the product workpiece height and width limit switch installation is not installed properly firm.
7.The gantry planer work table and bed and the tool frame shall not stand on people, store tools and other objects. Specific operation of the workforce can not cross the workbench.
8.The force on the handle of the bullhead planer should not exceed 8kg when the operating table is moved horizontally and 10kg when it is moved up and down.
9. Product workpiece loading and unloading, turning need to pay attention to the sharp edge, hairy edge scratching hands.

Notes on the use of electric planer.
1.The planer should be clamped, there should be a certain gap between the blade and the workpiece before work, the first time to eat the knife is not too deep, to prevent touching the blade or injury.
2.Operation is not allowed to stand in front of the bullhead planer, and not in front of the bullhead planer head down to check the work.
3.Adjust the machine stroke and tighten the bolts controlling the stroke.
4.Around the surface of the planer, install an upright cylindrical protection shield that can be turned up.
5.Clean the chips to concentrate in the special chip cutter. To avoid cutting stabbing foot.

VIDO is a professional tool manufacturer, producing many professional tools, such as chainsaws, electric planes, etc.. Products are exported overseas and have been well received by everyone, if you are interested in electric planes or other tools, welcome to contact our company.